PROFINET data alaways zero

[kadams]

How did u setup ur UR?

Make a small test programm.

Set ur digital output Q352.0 = True and then read that one at the UR:

and then do:

and check ur DI 104.0

also check ur settings at the UR…

I had some issues before with the adress:

Problems with adjusting the IP-Address

Good morning together, I´m facing an issue with the IP-Address of my UR10e. The UR is connected to a Siemens PLC and Siemens HMI. The IP Address are: PLC: 192.168.100.1 HMI: 192.168.100.2 UR: 192.168.100.3 When I set the adress via Siemens TIA v15.1 I can communicate between the Robot and my PLC. BUT!!! When i take a look at the Robot Panel it shows the IP adress of 192.168.100.3 NOT at its IP Address. It says the Standart Gateway Address is “192.168.100.3”… [image] When i try to cha…