I’m getting the subject error when running a program to tend CNCs. I’ve had it before but fixed it using wait and/or sync() nodes in the thread. This time it’s not working. I’ve rebooted polyscope and it worked once after that but failed the very next part. The error: [image] The original code: …

Might need to have sync() outside the if-statement Basically any time you create a thread you need to end it with a sync() command. This uses up any physical time remaining after the code is complete. Currently if that statement is false it sits there and doesn’t know what to do (at least this is h…

C271A1 Error during thread

Technical Questions

guillermojose.belda October 17, 2024, 7:56am 7

I have just got the same error after introducing a non related change. Solved after adding sync() at the end of each Thread

C271A1 error occurs even with a simple infinite loop

Topic		Replies	Views
Thread stops without warning URScript	8	501	May 24, 2023
Wait in script code error Technical Questions	5	1442	October 6, 2022
Optimal use of sync() function in nested loops URScript	5	2808	September 11, 2020
Protective stop error C271A3 low level real-time thread run time and communication out of sync Robot Communication	4	3179	March 27, 2021
When to use sync() URScript	2	6200	June 11, 2019

C271A1 Error during thread

Related topics